How to repair the electronic locker by yourself?

Step 1: The electronic locker is plugged in, but the screen does not light up. At this time, you need to use the central control key to open the access door, and then check whether the power cord is loose, and try to plug it in as tightly as possible. While checking the power plug, you can also check whether the plug between the motherboard and the power cord is loose.

Step 2: The single door of the electronic locker cannot be opened. At this time, the same reason is used to solve it with the exclusion method. First open the management page with administrator privileges, and forcibly open the door that cannot be opened. If it can be opened, it proves that there is no problem with the line. At this time, to see if the electric lock is stuck, press the electric lock with your hand. Insert it back, and push the door firmly to see if the lock and hook are fastened. If this happens, use pliers to snap the shackle from side to side to make sure the shackle and catch are well locked.

The third step is to forcibly open the door in the second step in front, but it cannot be opened. At this time, check whether the lock wire on the lock control panel is loose, unplug it, and plug it in again. Remember that it is also in the case of power failure, because there will be static electricity. Then check whether the wires on the control panel of the electric lock are loose.

If the door lock still cannot be opened after trying all the above methods, you can ask the manufacturer to solve it, or you can observe whether the door shaft on the electronic locker is a through shaft. If it is a thru-axle, use pliers to remove the axle. Pull down from top to bottom. At this time, if the door is disengaged from the door shaft, the door will automatically fall, at this time the lock is removed, and the manufacturer can send a new lock and reinstall it.

Another point is the paper jam of the barcode paper printer. At this time, open the access door with the administrative key, and then turn on the printer to see if there is any jammed paper inside. The printer is easy to disassemble because the card is stuck, and you can remove it by pressing it in with your hand, and then take out the jammed paper and install it again.

Through the above operations, if you are not skilled in the last step of assembly and disassembly, please do not disassemble and assemble by yourself, and do it under the guidance of the manufacturer, otherwise the door will fall and cannot be installed. Remember to pay attention when loading barcode paper, that is, thermal paper, in any case, the glossy side is the front side of the printing side.